Page 1 of 1
Any of ya'll weld aluminum around jackson?
Posted: Thu May 19, 2011 10:17 am
by DeltaCotton12
I have a couple of spots on my boat that need some attention. They are in the open spots. Nothing tough at all. A couple beads and it would be done. About 3" long or so. I have been working a hook out of the bottom of my boat and worked it a little much. I can send pictures if needed.
I do not want to go the J-B weld or any other temporary fix. I'd rather spend the $ up front and know it's fixed.
Any recommendations?
Re: Any of ya'll weld aluminum around jackson?
Posted: Thu May 19, 2011 11:09 am
by huntersmky
PM Sent
DeltaCotton12 wrote:I have a couple of spots on my boat that need some attention. They are in the open spots. Nothing tough at all. A couple beads and it would be done. About 3" long or so. I have been working a hook out of the bottom of my boat and worked it a little much. I can send pictures if needed.
I do not want to go the J-B weld or any other temporary fix. I'd rather spend the $ up front and know it's fixed.
Any recommendations?
Re: Any of ya'll weld aluminum around jackson?
Posted: Thu May 19, 2011 1:04 pm
by Chesapeake9487
Mid-state welding in Clinton.
Re: Any of ya'll weld aluminum around jackson?
Posted: Fri May 20, 2011 8:58 pm
by sondance
I bet some of te radiator shops could do it