advice needed: 11-87 won't eject dove loads
-
- Regular
- Posts: 46
- Joined: Mon Jan 07, 2002 1:01 am
- Location: kneedeep, ms
advice needed: 11-87 won't eject dove loads
any suggestions on getting a 3", light contour, premier 11-87 to cycle light loads? no problems w/ heavier loads.
light loads
clean it there are ports under the metal ring that you can clean out could be your problem take off forearm big ring that goes over magizineuse wire or small toothpick but a good over all cleanig you might also check the o ring good luck or try different brand of shells
-
- Regular
- Posts: 46
- Joined: Mon Jan 07, 2002 1:01 am
- Location: kneedeep, ms
- Bustin' Ducks
- Duck South Addict
- Posts: 1817
- Joined: Tue Dec 10, 2002 10:17 pm
- Location: Meridian, MS
- MemphisStockBroker
- Duck South Addict
- Posts: 3524
- Joined: Thu Sep 06, 2001 12:01 am
- Location: Olive Branch
- Bustin' Ducks
- Duck South Addict
- Posts: 1817
- Joined: Tue Dec 10, 2002 10:17 pm
- Location: Meridian, MS
You might check the spring that is located within the stock...NOT the spring on the outer piece but the spring on the INNER shaft that the stock slides onto....If you have been in flooded water and/or brackish/salt water...the spring may be on the verdge of rusting up..or seizing up..my 2 cents...
I may go to Heaven, or I may go to hell....But one thing is for certain..It'll be after Duck season!!
- Delta Duck
- Duck South Addict
- Posts: 2334
- Joined: Tue Jun 19, 2001 12:01 am
- Location: The Delta
- Contact:
SBE 

"Ducks on the Brain"
It's always better with a good dog and good friends, Ducks and no Terrorist!
http://www.DeltaDucks.com
It's always better with a good dog and good friends, Ducks and no Terrorist!
http://www.DeltaDucks.com
- mallardchaser
- Duck South Addict
- Posts: 1380
- Joined: Thu Jun 21, 2001 12:01 am
- Location: Madison
- Greenhead22
- Duck South Addict
- Posts: 19203
- Joined: Sun Apr 29, 2001 12:01 am
- Location: Mississippi/Louisiana/Arkansas
Who is online
Users browsing this forum: No registered users and 7 guests