Page 1 of 1
beretta sling swivels
Posted: Mon Apr 27, 2015 7:59 pm
by .tadpole
Where do I find a swivel that will replace the snap in push button swivel in the stock of my A391? I want to install a swivel that will accept a hush stalker sling.
Re: beretta sling swivels
Posted: Mon Apr 27, 2015 8:39 pm
by teul2
Re: beretta sling swivels
Posted: Tue Apr 28, 2015 6:58 am
by .tadpole
That's not it Joel. I've got that. I'm looking to take out that insert and I have already taken out the screw in insert that this snaps into. I need to replace that piece with another.
Re: beretta sling swivels
Posted: Tue Apr 28, 2015 8:06 am
by Smoke68
I've been through this. Don't recall what I found, but I didn't end up with what I needed. Talked to a gunsmith who had dealt with it; something about drilling holes in end caps, but having to reinforce due the metal being too thin to support a stud.
Good grief what a horrible design.
Re: beretta sling swivels
Posted: Tue Apr 28, 2015 8:38 am
by Greenhead22
I did away with the snap swivel and tapped the stock with a standard swivel insert.
Re: beretta sling swivels
Posted: Tue Apr 28, 2015 8:42 am
by .tadpole
The stock is already tapped just need the correct swivel for it
Re: beretta sling swivels
Posted: Tue Apr 28, 2015 12:17 pm
by teul2
Tad, see if this stud will work for what you are talking about.
http://www.shopunclemikes.com/detail/TCL+2500-0-1
Re: beretta sling swivels
Posted: Tue Apr 28, 2015 5:54 pm
by .tadpole
Swann's said they could fix it for $20. Let em have at it.
Re: beretta sling swivels
Posted: Wed Apr 29, 2015 7:19 pm
by CW
If swans doesn't work out try Midwest gun works or Rich Cole