mechanic - motor question

This forum is for general discussion that doesn't fit in the other topic-specific forums.
huntersmky
Duck South Addict
Posts: 2147
Joined: Wed Aug 13, 2008 10:37 am
Location: Madison by way of Quitman County

mechanic - motor question

Postby huntersmky » Fri May 06, 2011 8:18 am

I ran some bad gas through my truck last night. took me awhile this morning to get it cranked and when I did it was smoking pretty heavily and acted like it didn't have any power. What in the world could it be? will it correct itself by just letting it run or did I burn up a valve or something? I keep hearing a little ticking noise under the hood.
User avatar
4dawgma
Duck South Addict
Posts: 6346
Joined: Thu Feb 23, 2006 9:03 pm

Re: mechanic - motor question

Postby 4dawgma » Fri May 06, 2011 8:22 am

when was the last time you checked the oil?
Where'd who go?
huntersmky
Duck South Addict
Posts: 2147
Joined: Wed Aug 13, 2008 10:37 am
Location: Madison by way of Quitman County

Re: mechanic - motor question

Postby huntersmky » Fri May 06, 2011 8:51 am

User avatar
SHANE704
Veteran
Posts: 865
Joined: Fri Dec 08, 2006 2:00 pm
Location: Waynesboro, MS

Re: mechanic - motor question

Postby SHANE704 » Fri May 06, 2011 8:59 am

u check the oil everytime you start it?
Deltaquack
Duck South Addict
Posts: 2351
Joined: Sun Feb 10, 2008 8:27 pm
Location: Cleveland

Re: mechanic - motor question

Postby Deltaquack » Fri May 06, 2011 9:00 am

What about running SeaFoam or Heet through it.
huntersmky
Duck South Addict
Posts: 2147
Joined: Wed Aug 13, 2008 10:37 am
Location: Madison by way of Quitman County

Re: mechanic - motor question

Postby huntersmky » Fri May 06, 2011 9:03 am

huntersmky
Duck South Addict
Posts: 2147
Joined: Wed Aug 13, 2008 10:37 am
Location: Madison by way of Quitman County

Re: mechanic - motor question

Postby huntersmky » Fri May 06, 2011 9:04 am

User avatar
SHANE704
Veteran
Posts: 865
Joined: Fri Dec 08, 2006 2:00 pm
Location: Waynesboro, MS

Re: mechanic - motor question

Postby SHANE704 » Fri May 06, 2011 9:19 am

yeah sounds like a junked up carb
donia
Duck South Addict
Posts: 7127
Joined: Thu Aug 04, 2005 2:34 pm
Location: Starksville

Re: mechanic - motor question

Postby donia » Fri May 06, 2011 9:37 am

replace fuel filter as well...if it was really bad gas (sediment in it), you may be in for a few filter changes.
Experience is a freakin' awesome teacher...
huntersmky
Duck South Addict
Posts: 2147
Joined: Wed Aug 13, 2008 10:37 am
Location: Madison by way of Quitman County

Re: mechanic - motor question

Postby huntersmky » Fri May 06, 2011 9:56 am

User avatar
blackhawk0718
Duck South Addict
Posts: 1325
Joined: Sat Nov 24, 2007 4:03 pm
Location: brandon ms
Contact:

Re: mechanic - motor question

Postby blackhawk0718 » Fri May 06, 2011 11:11 pm

change filters. drain tank and run a couple of high octane tanks of fuel threw it along with like some marvel mystery oil for carbs and you should be okay. worst case get some new plugs. bad gas can cause your plugs to gunk up
Look out for dem danm COOTS
there every were
1010
Veteran
Posts: 475
Joined: Fri Jan 07, 2011 11:34 pm
Location: G MS
Contact:

Re: mechanic - motor question

Postby 1010 » Sat May 07, 2011 7:39 pm

What color was the smoke? blue is oil, could be a broken valve spring, broken rocker arm etc that would explian the mis fire.

Did the smoke stop after it ran a few min, that would just mean your valve seals leaked some oil into the cylinder no big deal. The ticking could be a lifter not primed, it should stop after a few min of starting.

Black is fuel, the above mentioned should help.
huntersmky
Duck South Addict
Posts: 2147
Joined: Wed Aug 13, 2008 10:37 am
Location: Madison by way of Quitman County

Re: mechanic - motor question

Postby huntersmky » Sun May 08, 2011 8:58 pm

1010
Veteran
Posts: 475
Joined: Fri Jan 07, 2011 11:34 pm
Location: G MS
Contact:

Re: mechanic - motor question

Postby 1010 » Sun May 08, 2011 9:12 pm

A stuck lifter, or the piston is hitting the valve from jumped time or out of time.
Bent valve.
OleMiss
Regular
Posts: 39
Joined: Sun Oct 05, 2008 2:48 pm

Re: mechanic - motor question

Postby OleMiss » Mon May 09, 2011 12:31 am

That old gas is bad for vavles!! When it reaches a certain age it will leave a bad sticky residue on the valves themselves and cause the pushrods to get bent! Take tank off...and have it professionally cleaned out then clean out your lines and carb also...once you get clean tank of gas going through you shouldnt have anymore problems.

Return to “General Discussion Forum”

Who is online

Users browsing this forum: No registered users and 56 guests