advice needed: 11-87 won't eject dove loads

This forum is for general discussion that doesn't fit in the other topic-specific forums.
Morning Wood
Regular
Posts: 46
Joined: Mon Jan 07, 2002 1:01 am
Location: kneedeep, ms

advice needed: 11-87 won't eject dove loads

Postby Morning Wood » Thu Sep 04, 2003 11:54 am

any suggestions on getting a 3", light contour, premier 11-87 to cycle light loads? no problems w/ heavier loads.
duckhnter
Regular
Posts: 96
Joined: Wed Jun 04, 2003 9:49 pm

Postby duckhnter » Thu Sep 04, 2003 12:09 pm

mine does the same thing. does not like light loads. but will kick the high brass loads out everytime. so i just shot the heavy loads
duckhnter[b][/b]
00ducksr.
Regular
Posts: 62
Joined: Fri Sep 20, 2002 12:26 pm
Location: memphis tn.

light loads

Postby 00ducksr. » Thu Sep 04, 2003 12:11 pm

clean it there are ports under the metal ring that you can clean out could be your problem take off forearm big ring that goes over magizineuse wire or small toothpick but a good over all cleanig you might also check the o ring good luck or try different brand of shells
Morning Wood
Regular
Posts: 46
Joined: Mon Jan 07, 2002 1:01 am
Location: kneedeep, ms

Postby Morning Wood » Thu Sep 04, 2003 12:26 pm

i did a thorough cleaning. you would be amazed at what builds up over a few years of swamp trudging. the ports were clear but the oring didn't seem to have much elasticity. where can i get another one w/out having to order from factory?
duckhuntr: did you try either of these fixes?
User avatar
Bustin' Ducks
Duck South Addict
Posts: 1817
Joined: Tue Dec 10, 2002 10:17 pm
Location: Meridian, MS

Postby Bustin' Ducks » Thu Sep 04, 2003 12:29 pm

the rubber O ring is typically the culprit...damn things...
I may go to Heaven, or I may go to hell....But one thing is for certain..It'll be after Duck season!!
User avatar
Deadeye
Duck South Addict
Posts: 1555
Joined: Wed Sep 12, 2001 12:01 am
Location: Brandon, Ms

Postby Deadeye » Thu Sep 04, 2003 12:36 pm

I had a brand new 11-87 that would not eject light loads right out of the box. I used it for turkey hunting and sold it a couple of years ago. Wish I had it back.
00ducksr.
Regular
Posts: 62
Joined: Fri Sep 20, 2002 12:26 pm
Location: memphis tn.

Postby 00ducksr. » Thu Sep 04, 2003 1:06 pm

go to any gunsmith shop they will have one hpoe this helps
User avatar
MemphisStockBroker
Duck South Addict
Posts: 3524
Joined: Thu Sep 06, 2001 12:01 am
Location: Olive Branch

Postby MemphisStockBroker » Thu Sep 04, 2003 1:32 pm

1. clean it and make it look pretty.

2. sell it in the Sunday newspaper and buy a real gun.


8)
Sometimes you just have to close your eyes, count to ten, take a deep breath and remind yourself that you wouldn't look good in prison stripes... and just smile at that dumbass and walk away.
User avatar
Bustin' Ducks
Duck South Addict
Posts: 1817
Joined: Tue Dec 10, 2002 10:17 pm
Location: Meridian, MS

Postby Bustin' Ducks » Thu Sep 04, 2003 3:23 pm

You might check the spring that is located within the stock...NOT the spring on the outer piece but the spring on the INNER shaft that the stock slides onto....If you have been in flooded water and/or brackish/salt water...the spring may be on the verdge of rusting up..or seizing up..my 2 cents...
I may go to Heaven, or I may go to hell....But one thing is for certain..It'll be after Duck season!!
User avatar
Delta Duck
Duck South Addict
Posts: 2334
Joined: Tue Jun 19, 2001 12:01 am
Location: The Delta
Contact:

Postby Delta Duck » Thu Sep 04, 2003 8:17 pm

SBE :lol:
"Ducks on the Brain"
It's always better with a good dog and good friends, Ducks and no Terrorist!
http://www.DeltaDucks.com
User avatar
ducman77
Duck South Addict
Posts: 2846
Joined: Sun May 19, 2002 12:01 am
Location: Winona

Postby ducman77 » Thu Sep 04, 2003 8:22 pm

I second the motion

SBE
shoot'm in the lips
User avatar
mallardchaser
Duck South Addict
Posts: 1380
Joined: Thu Jun 21, 2001 12:01 am
Location: Madison

Postby mallardchaser » Thu Sep 04, 2003 9:38 pm

Do you have a white f250? I saw a tag on the front of one the other day at the shell on 471 in brandon?
User avatar
ducman77
Duck South Addict
Posts: 2846
Joined: Sun May 19, 2002 12:01 am
Location: Winona

Postby ducman77 » Thu Sep 04, 2003 10:09 pm

No I drive A Chevy 2500HD
shoot'm in the lips
User avatar
Greenhead22
Duck South Addict
Posts: 19203
Joined: Sun Apr 29, 2001 12:01 am
Location: Mississippi/Louisiana/Arkansas

Postby Greenhead22 » Fri Sep 05, 2003 1:52 pm

The 11-87 is a jammomatic, just not as bad as the SBE that was recommended twice earlier.......... :lol: :lol: :lol:

I would say get a beretta or bgh, or even a EAA Baikal, been shooting mine alot lately and love it.
User avatar
ducman77
Duck South Addict
Posts: 2846
Joined: Sun May 19, 2002 12:01 am
Location: Winona

Postby ducman77 » Fri Sep 05, 2003 5:50 pm

GH22,
How many benellis have you had in the past. I shot mine all day today and was shooting light loads and did not jam up one time. If you clean a gun ever once in a while it want jam up.
shoot'm in the lips

Return to “General Discussion Forum”

Who is online

Users browsing this forum: No registered users and 58 guests